Filter
Top Products
C. Unpacking.
After unpacking the Model AM100H, examine it for damage that may have occurred in transit.
If the equipment has been damaged, do not attempt to install or operate it. File a claim
immediately with the carrier stating the extent of the damage. Carefully check all envelopes,
shipping labels and tags before removing or destroying them.
D. Mounting.
CAUTION
The selection of the mounting location for the device, its controls and the routing of the wiring is to
be accomplished under the direction of the facilities and the safety engineer.
The speaker is intended to be mounted on any relatively flat and rigid surface. Hardware for
mounting the speaker to the surface is left up to the installer.
WARNING
This unit is heavy and should be mounted on a rigid surface capable of supporting the weight
of the speaker.
NOTE
Position the supplied washer in the throat of the horn before installing the driver
E. Electrical Connections.
Refer to the instructions packed with the compression driver (AM100D recommended).
F. Service.
CAUTION
Any maintenance must be performed by a trained electrician in accordance with NEC guidelines and
local codes.
Do not perform maintenance on this device while the system power is on.
Federal Signal will service your equipment or provide technical assistance with any problems
that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied by
a Return Material Authorization. This R.M.A can be obtained from the local Distributor or
Manufacturer’s Representative.
At this time a brief explanation of the service requested or the nature of the malfunction,
should be given.
Address all communications and shipments to:
FEDERAL SIGNAL CORPORATION
Electrical Products Division
Service Department
2645 Federal Signal Drive
University Park, IL 60466-3195
-2-