Filter
Top Products
Rev 04.08.021 - 17 –
Figure 8
(+) 70V Mono Load (-)
output of the CV2502 to create a Mono 70V output at 500 Watts. Connect the positive (+) lead from the
distributed load to the 35V connector on Channel 2, and connect the negative (-) lead from the distributed
load to the 35V connector of Channel 1. Be sure that the sum of the output to each of the speakers on the
distributed load is less than 500 watts. (See Figure 8) It is also necessary to connect the commons
together when bridging a distributed load.
Caution: A 4 ohm mono load should not
be connected to the CV Series amplifier in the bridged
mode, but you can
use the parallel mono configuration with a 4 ohm load.
The table below lists the recommended “Bridged Mono” connections for a CV Series Dual Channel
amplifier using Class 2 Wiring. The user should note that it is possible to bridge the 70 V and 100V
terminals, however Class 1 Wiring should be observed
. All outputs will be 500 watts on the example
amplifier CV2502. (
See Table 2 below)
Bridged Mono Connections
(-) (+)
CH 1 CH 2 Connect to Bridged Load
4 ohm 4 ohm ------------------- 8 ohm load
8 ohm 8 ohm ------------------- 16 ohm load
Note!
25V 25V ------------------- 50V load
Class 2 wiring Approved
35V 35V ------------------- 70V load
50V 50V ------------------- 100V load
70v 70V ------------------- 140V load
Note!
100V 100V ------------------- 200V load
Class 1 Wiring Required
(+) 8 Ohm Mono Load (-)
Table 2