Filter
Top Products
28 Setup
Saving Parameters
Upon exiting setup mode, the prompt “Save All (Y/N)” blinks. Press Y or y to exit
setup and save settings in permanent (nonvolatile) RAM. Press C or c to cancel the exit
request. Press
N or n to exit Setup. The changes will take effect, but will be lost if the terminal is reset
or powered off.
An exception to this is function/edit key and answerback message programming.
Once edited in Setup, the changes are saved regardless of the way in which you exit
Setup.
Movement Inside Menus
F1 through F12: Select the menu that corresponds to the function key. Access to the
“EXEC” menu is available using either the Print (PC-style keyboards) or F13 (ANSI
keyboard) key. The keys are labeled at the top of each menu.
Cursor Control Keys (↑ ← ↓ →): These keys control movement to parameters within
the menu and is indicated by a highlighted selection bar. This selection bar will wrap
to the other side of the menu at the top, bottom and side boundaries. For each
parameter there are at least two choices. As the parameter is highlighted, the available
choices appear in the area above the help bar.
Some parameters are action fields and have no choices. See the Action Fields
section later in this chapter.
Enter and Shift-Enter: Cycle “up” or “down” through the choices for a given
parameter.