Filter
Top Products
Installation & Operations Manual
CR-25E Cable Beam Barrier Installation, Adjustment & Maintenance 6 of 31
© 2007 B&B ARMR WWW.BB-ARMR.COM (800) 367-0387
1.2 CR-25E Start Up Instructions
NOTE: These instructions assume installation has been completed. If
necessary, refer to the enclosed installation instructions.
1. Remove the rear operator door.
2. Connect power by flipping the disconnect switch to the "ON" position.
3. Test operate the barrier to be sure it is functioning properly.
1.3 CR-25E Shut Down Instructions
1. Remove the rear operator door.
2. Disconnect power by flipping the disconnect switch to the "OFF" position.
1.4 CR-25E Emergency Operation Instructions
1. Remove the rear operator door.
2. Disconnect power by flipping the disconnect switch to the "OFF" position.
3. Locate the hand-crank mounted inside the housing.
4. Slip the hand-crank onto the shaft extending through the brake. The brake will
automatically release.
5. Turn the hand-crank to raise or lower the barrier, as needed. A tag on the brake
indicates crank direction for opening or closing the barrier. (Clockwise for
“Close”, counter clockwise for “Open”).
6. Remove the hand-crank.
7. Flip the disconnect switch back to the "ON" position to resume powered
operation.