Filter
Top Products
Installation & Operations Manual
CR-25E Cable Beam Barrier Installation, Adjustment & Maintenance 18 of 31
© 2007 B&B ARMR WWW.BB-ARMR.COM (800) 367-0387
8) With the barrier in the fully raised or lowered position, loosen the lock nuts on the
connecting rods and turn the rods to increase or decrease their length. Adjust the rods
until the barrier arm is in the desired position.
NOTE: Adjusting the connecting rods changes both the raised and lowered position by
the same amount.
9) Run the barrier through several cycles to ensure proper starting and stopping points.
10) If the barrier panel travels slightly too far in either the open or closed direction, this
can be adjusted using the limit switches. It is important to note that adjusting the limit
switch at this point will stop the barrier arm before it has fully decelerated.