Filter
Top Products
ATON AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 86
Comm Ports
Comm Port one is preconfigured for the Sonance FS-22 or IW-22 docking station. Connect
the dock as shown in Figure 4-2 on page 35 or Figure 4-3 on page 36, depending on the
model of the dock.
Comm Port two is preconfigured for the RadioRA2 lighting system. Connect the lighting
system as shown in Figure 4-4 on page 37.
Relay
The on-board relay is NORMALLY OPEN by default. Selecting ANY source in Zone one will
activate the relay.
Lighting Commands
The OLED2 Touchpads are preconfigured to issue RadioRA2 phantom button commands
one through six. The table below shows the button name as it appears on the OLED2
interface and the corresponding lighting command.
Note: The lighting system must be programmed separately. It is recommended that the
lighting system be programmed to conform to the OLED2 buttons.
Default Button Configuration
for all zones.
OLED2 Button Press
All On All Off Day Night Party Away
RadioRA 2 Phantom Button 1 2 3 4 5 6