Filter
Top Products
ATON AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 21
Zone IR Input Connections
Each zone has a 3.5mm mono IR Input connector that allows IR commands from 3
rd
party
controllers to be used without the need to splice into the Touchpad Input connections.
Simply connect a 3.5 mono cable from the IR output port of the 3
rd
party controller to the
Zone IR input jack for the zone you wish to control.
Figure 3-3: Zone IR Inputs
Source IR Output Connections
The AH66T features 6 source-specific IR emitter outputs. Each of these outputs is active
only when the assigned source is selected. This makes it possible to use identical source
components and still have the capability of separate control. For sources such as a multi-
output music server, the ATON configuration software can route IR for either output to the
same IR port, eliminating the need to use IR “Y” cables.
Figure 3-4: Source IR Outputs
When connecting multiple AH66T chassis, it is only necessary to connect IR sources to
chassis # 1. The IR LOOP PORTS provide a link between chassis to route IR from zones
on the second chassis to the Source IR Outputs of the main chassis..