Filter
Top Products
ATON AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 80
Scan Presets Command
Description: Scans through presets. Plays the station for 10 seconds and then goes to the
next station. This continues until another command is sent to the tuner.
Examples:
&AH66,R1,SCAN,UP<cr> Starts CHASSIS ONE’S (R1) radio SCANNING (SCAN)
UP (UP).
&AH66,R2,SCAN,DOWN<cr> Starts CHASSIS TWO’S (R2) radio SCANNING (SCAN)
DOWN (DOWN).
When another command is sent to the tuner, it will stop scanning and execute the next
command.
It is recommended to use the CANCEL command to stop scanning to avoid any
unintended result. See page 74 for the CANCEL command.
Seek Command
Description: Tunes the radio to the next valid station.
Examples:
&AH66,R1,SEEK,UP<cr> TUNES (SEEK) CHASSIS ONE’S (R1) radio to the next
valid station of a HIGHER FREQUENCY (UP).
&AH66,R2,SEEK,DOWN<cr> TUNES (SEEK) CHASSIS TWO’S (R2) radio to the next
valid station of a LOWER FREQUENCY (DOWN).
Prefix TS Parameter 1
Group
Parameter 2
&AH66 R1/R2 SCAN UP/DOWN
Prefix TS Parameter 1
Group
Parameter 2
&AH66 R1/R2 SEEK UP/DOWN