Filter
Top Products
ATON AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 30
Multi-Chassis Connections
Additional connections are required when using two AH66Ts in a system. These
connections allow IR, A-Net information, Source Audio and RS-232 Control to be shared
between the chassis.
Source Audio Inputs
In a dual AH66T system, it is necessary to use RCA “Y” cables to allow Source Audio to be
shared between the two chassis. The exception to this is the integrated AM/FM Tuner,
which is covered starting on page 34 of this manual.
Integrating each source will require two “Y” cables, one for the left channel audio and one
for the right channel audio. Connect the male ends to the Source Audio Inputs of the
AH66Ts and the female ends to RCA cables connected to the sources’ audio outputs. Be
sure that each source connects to the same Source Audio Input on BOTH chassis.
Figure 3-17: Source Audio “Y” Connections