Filter
Top Products
42
So, if the IP addresses assigned in your network use
192.168.001.xxx and the last three digits of 101 have not
been assigned to any other device, you do not need to change the
IP address already assigned during manufacture. Attention: Your
operating system may not display zeros, i.e. the entry on your PC
can also be 192.168.1.1 (instead of 192.168.001.001).
If you want to change the IP address of the DAR300 because of
your network configuration:
Select "IP Address" and press OK.
Press or to go to the digits you want to change and enter the
desired digits using the number blocks on the remote control.
Press and confirm by pressing OK.
Press . A window is displayed with the question "Accept
changes?"
Press Yes to confirm the changes.
Press No to discard the changes.
Press OK.
Press to set the parameters.
Subnet screen
The IP address can only be entered if the Auto Config setting is
"Off".
The default setting is 255.255.255.000. This setting is used
in nearly all networks.
Press to set the parameters.
Gateway
The IP address can only be entered if the Auto Config setting is
"Off". The connection to the Internet title database or Internet
radio stations takes place via the gateway. The IP address of your
DSL router should be entered here.
The default setting is 192.168.1.1. This setting is used in
nearly all networks.
Press to set the parameters.
DNS server
The IP address can only be entered if the Auto Config setting is
"Off".
Enter the IP address of the DNS server.
Press to set the parameters.
Hostname
The default setting is "DAR300".
Devices can be identified on the network by their IP address and
their hostnames (e.g. using the "Browse computers" search
function in Windows XP).
The hostname can also be used to establish a network connection
under Windows:
Explorer -> Tools -> Map Network Drive...
\\DAR300\Music.
You should use a DHCP server for the configuration of your
network, if you want to establish a connection to the DAR300
instead of the IP address for the hostname.