Filter
Top Products
13
Basic functions
1. Turning the DAR300 on and off
The central mains switch is located on the rear panel above the mains plug.
Turn the switch to ON (symbol I) after connecting all your components.
The red button on the remote control and the On/ Standby button on
the DAR300 are used to turn the device on or off, as well as to go into standby
mode.
There are three operating states:
1) Off – The DAR300 uses no power.
2) On – The DAR300 is ready to play music and/or show pictures,
etc.
3) Standby – The DAR300 is in standby mode and requires only
minimal power. The advantage of standby mode is that it take just
a few seconds to turn the device back on.
To turn the device on, off or go into standby mode:
Turn on: Press briefly.
Standby: Press
briefly.
Turn off: Press
longer, regardless of whether the device is on or in
standby mode.
Chapte
r
8