Filter
Top Products
21-EN
Erasing Disc Title
1 When the monitor display is open, press the
TITLE button to select the disc titling mode.
Then, press and hold the button for at least 3
seconds.
2 Press and hold the -/J button for at least 2
seconds to activate the title scanning mode. The
title in the display will blink.
3 Press the g DN or f UP button repeatedly
until the disc title you want to erase is displayed.
4 Press and hold the -/J button for at least 2
seconds to erase the disc title displayed.
5 Press and hold the TITLE button for at least 3
seconds to cancel the disc title erasing mode.
NOTE
You cannot erase a CD-TEXT.
Controlling CD Changer
An optional 6-disc or 12-disc CD Changer may be
connected to the CVA-1003R if it is Ai-NET
compatible. With a CD Changer connected to the
Ai-NET input of the CVA-1003R, the CD Changer
will be controllable from the CVA-1003R.
Using the KCA-400C (the Multi-Changer
Switching device) multiple changers can be
controlled by the CVA-1003R.
See the Multi-Changer Selection section on page
22 for selecting the CD Changers.
NOTE
The controls on the CVA-1003R for CD Changer
operation are operative only when a CD Changer is
connected.
1 Press the SOURCE button to activate the CD
changer mode. The display shows the disc
number and track number.
NOTE
The source indicator varies depending on the connected
source.
CD Player/Changer Operation (Optional)
2 Press the Disc Select buttons (1 through 6)
corresponding to one of the discs loaded in the
CD Changer. The selected disc number appears
in the display and CD playback starts.
NOTES
• After selecting the desired disc, you can operate in the
same way as for the CVA-1003R CD player.
For details, please see the CD Operation section.
• When the "FUNC" indicator is lit in red in the monitor
display, or is lit in the sub display, the disc select
buttons become nonfunctional.
When a 12-disc CD Changer is connected:
To select discs numbered from 1 to 6, the
procedure is the same as for the 6-disc CD
Changer. To select discs numbered from 7 to 12,
first press the FUNC button. In the sub display,
this changes the "D" indicator to "d." The "FUNC"
indicator is lit in yellow on the monitor display.
Then press the desired Preset button. With the
FUNC button activated, the Preset buttons 1 to 6
will represent discs 7 to 12 respectively.