Filter
Top Products
13-EN
Recalling Preset RDS Stations
1 Press the FUNC button so that the FUNC
indicator appears in the sub display. To perform
the same operation with the monitor display
open, press the FUNC button only when the
"FUNC" indicator lights red in the monitor
display.
2 Press the AF button to activate the RDS mode.
The display shows "AF" when the RDS mode is
activated.
3 Press the FUNC button to activate the normal
mode.
The FUNC indicator will turn off.
4 Make sure that the FUNC indicator light goes
out, then press the preset button in which your
desired RDS station is preset.
If the preset station's signal is weak, the unit
automatically searches and tunes to a stronger
station in the AF (Alternative Frequencies) list.
5 If the preset station and the stations in the AF list
cannot be received:
When the PI SEEK setting is on (refer to "PI
SEEK Setting" on this page), the unit searches
again for a station in the PI (Programme
Identification) list.
If there are still no stations receivable in the area,
the unit displays the frequency of the preset
station and the preset indicator disappears.
If the signal level of the Regional (Local) station
being tuned becomes too weak to receive, press
the same preset button to tune in a Regional
station in other district.
NOTE
For presetting the RDS stations, refer to the Radio
Operation section. The RDS stations can be preset in the
FM1, FM2 and FM3 bands only.
Receiving RDS Regional (Local)
Stations
1 When the monitor display is open, press and
hold the SETUP button for at least 2 seconds.
The SETUP screen appears.
2 Press the Preset 4 button to activate the RDS
setting mode. Press the Preset 4 button again to
select REGIONAL.
3 Press the g DN or f UP button to turn off
or on the REG (Regional) mode.
In the REG OFF mode, the unit automatically
keeps receiving the related local RDS station.
To set another setting, press the Preset 4 button
or another Preset button.
4 After setting is completed, press the SETUP
button to return to normal mode.
PI SEEK Setting
1 When the monitor display is open, press and
hold the SETUP button for at least 2 seconds.
The SETUP screen appears.
2 Press the Preset 4 button to activate the RDS
setting mode. Press the Preset 4 button again to
select PI SEEK.
3 Press the g DN or f UP button to set PI
SEEK to ON/OFF.
To set another setting, press the Preset 4 button
or another Preset button.
4 After setting is completed, press the SETUP
button to return to normal mode.
RDS Operation