Filter
Top Products
14-EN
Receiving Traffic Information
1 Press the T.INFO button to activate the Traffic
Information mode.
2 Press the g DN or f UP button to select
your desired traffic information station. When a
traffic information station is tuned in, the TP
indicator lights up.
Traffic information is heard only when it is being
broadcast. If traffic information is not being
broadcast, the unit is set in the standby mode.
When a traffic information broadcast begins, the
unit automatically receives it and the monitor
display shows “TRF-INFO” during the traffic
information broadcast (sub display shows "TRF-
INFO" for 2 seconds, then returns to the previous
display.)
When traffic information broadcast is over, the
unit will automatically set in the standby mode.
3 Press the T.INFO button to activate the normal
mode.
NOTES
• If the traffic information broadcast signal falls below a
certain level, the unit remains in the receiving mode
for 1 minute. If the signal remains below a certain
level for over 1 minute, the "T.INFO" indicator blinks.
• If you do not want to listen to the traffic information
being received, lightly press the T.INFO button to skip
that traffic information message. The T.INFO mode
will remain in the ON position to receive the next
traffic information message.
• If the volume level is changed while receiving traffic
information, the changed volume level will be
memorized. When traffic information is received next
time, the volume level will be automatically adjusted
to the level memorized.
• In the T.INFO mode, the SEEK tuning selects only the
TP stations.
gg
gg
g DN
ff
ff
f UP
FUNC
P.PTY
PTY
T.INFO
RDS Operation
PTY (Programme Type) Tuning
1
Press the FUNC button so that the FUNC
indicator appears in the sub display. To perform
the same operation with the monitor display
open, press the FUNC button only when the
"FUNC" indicator lights red in the monitor display.
2
Press the PTY button to activate the PTY mode,
while the unit is in Radio (FM Receiving) mode.
The Programme Type of the station being
currently received will be displayed for 5 seconds.
If there is no receivable PTY broadcast, "NO
PTY" will be displayed for 2 seconds.
NOTE
If no button is pressed within 5 seconds after pressing the
PTY button, the PTY mode will be automatically
cancelled.
3 Press the g DN and f UP buttons within 5
seconds after activating the PTY mode to
choose the desired programme type while the
PTY (programme type) is being displayed. Each
press scrolls the programme type by one.
→ LIGHT M → CLASSICS → OTHER M
4
Press the PTY button within 5 seconds after
selecting the programme type to start searching for
a station in the selected programme type.
In the sub display, the desired programme type
indicator blinks during the search, and lights when a
station is found. In the monitor display, “PTY SEEK”
is displayed during the search, and the current
programme type name appears if the station is
found.
If no station is found, "NO PTY" will be displayed
for 2 seconds.
5 Press the FUNC button to activate the normal
mode. The "FUNC" indicator will turn off.