Filter
Top Products
To reset
If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.
1 Press POWER to turn off the power.
2 Press POWER to turn the power back on while pressing CLEAR. Everything stored in memory after purchase
is canceled.
If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord, and
connect it again. Then carry out step 2.
GENERAL (cont.) pg. 36
MD GUIDE MESSAGES
Message Cause Solution
Blank disc Nothing is recorded on the disc. ---
Can't Edit The disc is record-protected. Slide the record-protect tab on the
disc. (See page 22.)
Tracks are too short to be joined. See "THE LIMITATIONS OF MD" on
page 24.
The combine function was used
while playing back the first track.
Disabled
The divide function was use at the
beginning of the track.
The combine function was used to
join a track recorded in monaural
with a track recorded in stereo.
Programmed play or random play is
activated.
Cancel the programmed play or
random play.
Disc Error The disc is damaged by scratches. Replace the disc.
The unit received a strong shock
during a TOC reading.
Do not subject the disc to strong
shock during a TOC reading.
Disc Full There is not enough time remaining
on the disc to record.
Replace the disc with another
recordable disc.
Temp Over The temperature of the unit is too
high.
Leave the unit in a cool place for a
while before operating in again.
The surrounding temperature is too
high or too low.
Operate the unit at moderate room
temperature.
Emergency The unit operates abnormally due to
a scratched disc or strong shock.
Replace the disc. Do not subject the
disc to a strong shock.
PB Disc There is an attempt to record or edit
a prerecorded music disc (optical
disc).
Replace the disc with a recordable
one.
Protected The disc is record-protected. Slide the record-protect tab on the
disc (see page 22.)
TOC Full There are too many tracks or
emphasis data to be recorded or
edited, or there is no room on the
disc.
Erase tracks.