Filter
Top Products
GENERAL pg. 31
CARE AND MAINTENANCE
Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit.
To clean the cabinet
Use a soft and dry cloth. If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents, such as alcohol, benzine or thinner as these could damage the finish of the unit.
To clean the heads
When the tape heads are dirty;
- high frequency sounds is not emitted
- the sound is not adequately high
- the sound is off-balance
- the tape cannot be erased
- the tape cannot be recorded on
After every 10 hours of use, clean tape heads with a head cleaning cassette.
Use separately sold dry-type or wet-type cleaning cassette.
Refer to the instructions of the cleaning cassette for details.
To demagnetize the heads
The tape heads may become magnetized after long-term use.
This may narrow the output range of recorded tapes and increase noise.
After every 20 to 30 hours use, demagnetize the tape heads with a separately sold demagnetizing cassette.
Refer to the instructions of the demagnetizing cassette for details.
Care of discs
• When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth.
• After playing a disc, store the disc in its case. Do not leave the disc in places that are hot or humid.
Care of tapes
• Store tapes in their cases after use.
• Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the
sound quality and cause noise.
• Do not expose tapes to direct sunlight, or leave them in a car
To reset
If an unusual condition occurs in the display window, the cassette decks or CD player, reset the unit as follows.
1 Press
POWER
to turn off the power.