Filter
Top Products
MUTE again. Each time the button is pressed, a 4-second blank space is added.
"Can't REC" is displayed if you attempt to record on a tape with the plastic tabs broken off.
To erase a recording
Make sure the microphone(s) is(are) not connected to this unit and set the microphone volume and the echo level to
OFF. (page 23). Also, check to make sure that BEAT and AUTO SPICE are switched off (page 8).
1 Insert the tape to be erased into deck 2 and press TAPE/DECK 1/2 to display "TP 2".
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing REV MODE (DECK 2).
4 Press REC/REC MUTE to start the erasure.
RECORDING (cont.) pg. 20
DUBBING A TAPE MANUALLY
Preparation
• Set the tape to the point where recording will start.
• The reverse mode is automatically set to . Note that recording will be done on one side of the tape only.
1 Press TAPE/DECK 1/2.
2 Insert the original tape into deck 1 and the tape to be recorded on into deck 2.
Insert the tapes with the sides to be played back or recorded on facing out from the unit.
3 Press DOLBY NR to turn off the Dolby NR.
NR on the display goes out.
4 Press TAPE/DECK 1/2 to select deck 1.
"TP1 " is displayed.
5 Press REC/REC MUTE to start recording.
Playing and recording start simultaneously.
To stop dubbing