Filter
Top Products
Keep DOWN or UP pressed until the frequency starts to change rapidly. After tuning in to a station,
the search stops. To stop the Auto Search manually, press DOWN or UP.
• The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control so that "MONO" appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again so that MONO disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency
allocation system is 9 kHz/step, change the tuning interval.
Press POWER while pressing . To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are cleared. The preset stations have to be set again.
PRESETTING STATIONS
The unit can store a total of 32 preset stations. When a station is stored, a preset number is assigned to the station.
Use the preset number to tune in to a preset station directly.
1 Press the TUNER/BAND to select a band, and press DOWN or UP to select a station.
2 Press SET to store the station.
A station is assigned a preset number, beginning from 1 in consecutive order for each band.
3 Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations for all the bands have already been stored.
"FULL" is displayed if you attempt to store more than 32 preset stations.