Filter
Top Products
DOLBY PRO LOGIC (cont.) pg. 24
PLAY WITH DOLBY PRO LOGIC
1 Press VIDEO/AUX and start playback of the video source.
"VIDEO" is displayed.
If "5.1 ch IN" is displayed, press
VIDEO/AUX
again.
2 Press DOLBY PRO LOGIC.
"NORMAL" is selected, and the playback sound has the DOLBY PRO LOGIC effect.
To cancel Dolby Pro Logic mode
Press
DOLBY PRO LOGIC
repeatedly until "PRO-OFF" is displayed.
To change the sound levels during playback
After adjusting the balance with the noise sequencer, the sound levels of the center or each surround speaker can be
adjusted during playback of laser discs or video software.
1
Press
MANUAL SELECT
on the remote control repeatedly to select "CEN" (center) or "S-R" (right surround
speaker) or "S-L" (left surround speaker).
2
While the "CEN" or "S-R" or "S-L" is displayed, press or on the remote control to adjust the
volume.
ADDITIONAL DOLBY PRO LOGIC MODES
In addition to the NORMAL mode, this unit is also equipped with the PHANTOM and the 3 STEREO modes.
PHANTOM mode:
Use this mode when no center speaker is connected. The center channel signals are output
through the left and right speakers.
3 STEREO mode:
Use this mode when no surround speakers are connected. This mode reproduces rear sounds