3M XT-1 Headphones User Manual


 
Appendix: Greeter Module
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
November 6 2014 – Revision 2.1
Page 67 of 77
1.
Navigate to
Playback After Delay Of >XX< Seconds
where
“xx” represents the current number of seconds.
2.
Change the number of seconds to a new value. The range is 0 to 15
seconds.
Change Playback Mode
Perform the following procedure to change the greeter playback mode.
1.
Navigate to
Playback Mode
.
2.
Change the value of the playback setting. Your choices are:
ALTERNATING
—A different message plays for each vehicle that
pulls up to the customer order point. Multiple messages must be
selected.
PLAY ONCE
—All messages selected play once for every vehicle
that pulls up to the customer order point.
Set Greeter Playback through Headsets
You have the choice of allowing the greeting to be played through the headsets
in addition to being played to the customer at the order point.
Perform the following procedure to enable or disable playback through headsets:
1.
Navigate to
Playback To The Headsets?
.
2.
Change the value of the playback setting. Your choices are:
YES
- The greeting will play on the headsets as well as the order
point.
NO
- The greeting will only be heard at the order point (and the
monitor if selected below).
:GREETER MESSAGE PROPERTIES:
Playback Through The Monitor?<YES>
Tone To Headsets During Playback?<NO >
Restaurant Closed Playback Message<OFF>
Set Playback through Monitor
You have the choice of allowing the greeting to be played through the
monitoring speaker in addition to being played to the customer at the order
point.
Perform the following procedure to enable or disable playback through the
monitor:
1.
Navigate to
Playback Through The Monitor
.
2.
Change the value of the playback setting. Your choices are:
YES
- The greeting will play on the grill monitor speaker as well
as the order point.
NO
- The greeting will only be heard at the order point.
Turn on Tone to Headsets During Greeter Playback
If the greeting is not playing over the headsets, a continuous tone can be played
while the customer is hearing the greeting. This permits the order taker to know
when the greeting is playing and when it has stopped.
To enable or disable the tone during greeter playback:
1.
Navigate to
Tone To Headsets During Playback
.