Filter
Top Products
Operation
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
November 6 2014 – Revision 2.1
Page 45 of 77
Note:
Your system may be configured with fewer order taking mode options than
the number described in this section. You must enter User configuration
(passcode required) to enable or disable individual order taking modes.
Explanation of Order Taking Modes
The following table shows how each order taking mode affects components and
settings in the system. The paragraphs that follow the table explain the meaning
of information in the table.
Order Taking
Mode
Listen Talk Vehicle
Detector
Automatic
Standby
Order Point
ML/PTT Manual Push to
Talk
Presence On Used
ML/MLT Manual Manual
Latching
Presence On Used
AL/PTT Automatic Push to
Talk
Presence On Used
AL/MLT Automatic Manual
Latching
Presence On Used
Hands Free Automatic Automatic Presence On Used
Outside Manual Manual
Latching
Ignored Off Not Used
Always On Always
on
Manual
Latching
Ignored Off Used
Listen: Auto, Manual, and Always On
In
Manual Listen
(ML), the operator must press the talk lane button to turn on
the order point microphone (to hear the customer order). The order point
microphone will remain on until the vehicle leaves.
In
Automatic Listen
(AL), the order point microphone turns on and stays on
whenever a vehicle is detected. The order point microphone will remain on until
the vehicle leaves.
In
Always On
, the order point speaker is always on so the customer can always
be heard regardless of whether a vehicle is detected at the order point.
Always
On
is a special failure mode that is useful if the vehicle detector cannot be used.
Talk: Manual Latching, Push to Talk, Automatic
In
Manual Latching Talk
(MLT), the operator must press and release the talk
lane button to “latch” or lock the headset microphone in the on position. The
operator can continue to speak hands free until the talk button is pressed and
released again. When
Automatic Standby
is on (see below), the microphone will
also be turned off when the vehicle is no longer detected.
In
Push to Talk
(PTT), the operator must press and hold the talk button while
speaking into the headset microphone. Releasing the button turns off the
microphone.
In
Hands Free
, the headset microphone is on whenever the order point vehicle
detector detects a vehicle. Because
Automatic Standby
(see below) is also on
when
Hands Free
is On, the microphone is turned off when the vehicle is no
longer detected.