Filter
Top Products
Operation
November 6 2014 – Revision 2.1
Page 34 of 77
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
Indicator LED Lights
T 2
Volume Control
PAGE
T1
Adjustment
Slide
Battery Latch
Identification Tag
Component Identification and Description
• Adjustment Slide: Push or pull to adjust for a comfortable fit.
• Indicator LED: The indicator LEDS on the headset indicates operating status of
the headset. The indicator LEDs on the battery indicates the current charge level
in the battery. See Headset and Battery Indicator Light Modes below.
• T1 and T2 (Talk:buttons): Connect you to the order point.
1. When there are two order points, T1 connects to order point 1 and T2
connects to order point 2.
2. When there is only one order point, T1 and T2 both connect to the order
point.
3. If you are in Manual Latching or Hands Free modes, the talk button
establishes you as the order taker; and while you are the order taker, the talk
button is an order point mute button (each tap turns mute on or off to the
order point).
• Volume: Slide your finger up and down the Volume control area to set
volume on the headset. Upward motion increases the volume while the
downward motion decreases the volume..
• Page: Has several functions related to in-store communication:
a) Talk to all headsets on the same lane (or both lanes depending upon
the configuration), but not to the order point. Press and hold the page
button during normal operation to communicate with other headsets.
There is an option in Global settings to allow the order taker to hear or
not to hear page messages.
b) Release the order-taker. If the order taker taps the page button, he or
she is no longer the order taker. The next person to press a talk button
becomes the order taker.
c) Enter page monitor mode, which permits you to hear only pages and
not any order taking activity. Starting with the power off on the
headset, press and hold the page button while turning it on to enable
page monitor mode. The headset will stay in this mode until it is
powered off and back on.
d) Enter temporary page monitor mode. If an operator (but not the active
order taker) taps the page button, the headset will hear only pages and
not any order taking activity. The headset will stay in this mode until
the operator taps the talk button.