Filter
Top Products
Operation
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
November 6 2014 – Revision 2.1
Page 47 of 77
•
The headset buttons T1 and T2 communicate only with order point 1
and order point 2, respectively.
•
For paging, pressing the page button on a lane 1 headset is only heard
by other lane 1 headsets. Likewise pressing the page button on a lane 2
headset is only heard by other lane 2 headset.
Notes:
A headset becomes a “lane 1” or “lane 2” headset by momentarily pressing
and releasing the T1 or T2 button.
You can configure the base stations to permit paging to be heard by both
lanes. Refer to configuration section of the manager’s guide.
Cross Lane
Cross Lane
mode is the preferred mode for lighter volume or whenever one
order taker needs to answer both order points: essentially, the two order points
cross over.
•
Operators will hear signals from both order points: single repeating
beep from order point 1 or a double repeating beep beep from order
point 2.
•
The headset buttons T1 and T2 communicate only with order point 1
and order point 2, respectively.
•
For paging, pressing the page button is heard by all headsets.
Change Volume Mode
If you have night volume reduction in use on your system, the volume change
happens automatically at the set “Day” and “Night” times. However, you can
change the volume mode manually without changing the day or night time
setting.
Perform the following procedure to change between night and day or day and
night volume:
1.
Press
until the
Volume
selection is highlighted.
2.
Press
Enter
.
3.
Use the arrows to select between
DAY
and
NIGHT
.
4.
Press
Enter
to implement the change or press
Mode
to abandon the
change and leave the previous setting in effect.