Filter
Top Products
This special effect adds a predelay to the pitch shifter, with the repeated sound being gradually shifted in pitch.
This is an intelligent pitch shifter which divides the original sound into two components (L and R) and creates diatonic
harmonies with different scales for the two sides.
HPS: 2-voice Harmonized Pitch Shifter
PitD: Pitch Shifter-Delay
■
56
Effect Types and Parameters
UTILITY
PAGE
PitD PIT= TIM=
FB= BAL=
PitD
RTM= DIR=
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
qw
er
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
ty
PAGE 1
PAGE 2
qw
er
ty
q PIT (Pitch) Controls the pitch shift within
±1 octaves.
-12
–
+12
w TIM (Time x10ms) Sets the predelay time in 10-ms steps.
0
–
100
e FB (Feedback) Sets the predelay repeat amount.
0
–
10
r BAL (Balance) Sets the balance between original sound and effect
sound. Higher values result in more pronounced
effect sound.
0
–
100
t
RTM (RTM Destination)
Sets the parameter to be controlled by RTM.
PIT, FB, BAL
y
DIR (RTM Direction)
Sets the RTM direction.
NML, INV
Parameters Comment Values
UTILITY
PAGE
HPS ScL= LvL=
ScR= LvR=
HPS DRY= KEY=
RTM= DIR=
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
qw
er
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
ui
ty
PAGE 1
PAGE 2
qw
er
ui
ty
q ScL (Scale L) Sets the harmony interval on the L side.
The following settings are available:
-6t (perfect sixth down)
-5t (perfect fifth down),
-4t (major fourth down),
-m3 (minor third down),
-M3 (major third down),
+M3 (major third up),
+m3 (minor third up)),
+4t (perfect fourth up),
+5t (perfect fifth up),
+6t (perfect sixth up),
w LvL (Level L) Sets the effect sound level on the L side.
0
–
100
e ScR (Scale R) Sets the harmony interval on the R side.
The following settings are available:
-6t (perfect sixth down)
-5t (perfect fifth down),
-4t (major fourth down),
-m3 (minor third down),
-M3 (major third down),
+M3 (major third up),
+m3 (minor third up)),
+4t (perfect fourth up),
+5t (perfect fifth up),
+6t (perfect sixth up),
r LvR (Level R) Sets the effect sound level on the R side.
0
–
100
t DRY (Dry Level) Sets the original sound output level.
0
–
100
y KEY (Key) Sets the tonic key of the scale. The following
settings are available:
C, C#, D, D#, E, F,
F#, G, G#, A, A#, B
u
RTM (RTM Destination)
Displays the parameter that is being controlled by
RTM. When "WLv" (Wet Level) is selected, "LvA"
and "LvB" are controlled simultaneously.
LvL, LvR, WLv
i
DIR (RTM Direction)
Sets the RTM direction.
NML, INV
Parameters Comment Values
KEY=C
Direct
Scale L
= + M3
Scale R
= – 4t
Examples