■
40
Advanced Operation
Using the USER FUNCTION switch to select PRESET A/B/C
In Play mode, press
the three
times to call up the
page shown below.
This is the page for selecting the
function of the USER FUNCTION
switch.
UTILITY/PAGE key
1
Use 2 to
set the "USER
FUNCTION=" item to
"PRESET".
Data entry knob
2
Press the
two
times.
The Utility mode settings are stored
and the unit returns to the Play
mode.
STORE/EXECUTE key
3
Press the
while
playing the instrument
in Play mode.
The new PRESET group (folder) will
be briefly shown on the display,
such as "Pfold=B", and the group is
switched.
USER FUNCTION switch
4
Select a patch from
the new PRESET
group.
The new patch becomes active.
("Selecting a patch" p. 11).
5
CONTROL
PEDAL
CONTROL
PEDAL
CONTROL
SWITCH
DECREASE
–(TAP/HOLD)
INCREASE
BANK
MAX
CONTROL
SWITCH
INDICATOR
1/2
MIN
BLINK
(DLY:TAP)
COMP EFF1 DIST EQ EFF2 EFF3 DLY REV TOTAL
EDIT
EXIT
TYPE
–+
PRESENCE OUTPUT
GROUP
COMPARE
FINE TUNE
Super
ADVANCED GUITAR EFFECTS PROCESSOR
STORE
(EXECUTE)
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
UTILITY
PAGE
USER
FUNCTION
2
4
3
1
Display
STORE/EXECUTE key
STORE
(EXECUTE)
USER FUNCTION switch
USER
FUNCTION
MAXMIN
Data entry knobs 1-4
UTILITY
PAGE
UTILITY/PAGE key
USER FUNCTION=MANUAL
3
USER FUNCTION=PRESET
3
B05 8080LEAD LVL= 80
AMP ¡VOL ™OFF ßHLD
If Utility mode settings are not stored, they will remain active only until the unit is next turned off. When turned on again,
the unit reverts to the previous settings. If you wish to keep changes you have made, do not forget to press the
STORE/EXECUTE key twice to perform the store process. Note that any edited patch will also be stored at this time.
Simply pressing the USER FUNCTION switch does not yet change the currently selected patch.
NO
✎
NO
✎
The USER FUNCTION switch can be used to select a group among PRESET groups A, B, C. To do this, the
function of the USER FUNCTION switch must be set to "PRESET" in Utility mode.
A01 8080LEAD LVL= 80
AMP ¡VOL ™OFF ßHLD
A01 8080LEAD Pfold=B
AMP ¡VOL ™OFF ßHLD
B01 8080LEAD LVL= 80
AMP ¡VOL ™OFF ßHLD
USER
FUNCTION
Press
USER FUNCTION switch