Filter
Top Products
78
PROBLEM
This unit will not operate properly.
A source cannot be recorded by a tape deck
or VCR connected to this unit.
Noise from nearby TV or tuner.
The sound is degraded when listening with
the headphones connected to the compact
disc player or cassette deck that are
connected with this unit.
POSSIBLE CAUSE
The internal microcomputer has been frozen by an
external electric shock (lightning, excessive static
electricity, etc.) or power supply with low voltage.
The source unit is connected to this unit between
digital jacks only.
This unit is too close to the affected equipment.
The power to this unit is off.
WHAT TO DO
Unplug the AC power cord from the wall AC outlet, and then plug in again
after about one minute.
Make additional connection between analog jacks.
Move the unit further away from the affected equipment.
Turn the power to this unit on.
PROBLEM
The remote control unit does not work.
The remote control unit does not function
properly.
Learning cannot be made successfully.
(The TRANSMIT/LEARN indicator does not
light up or flash.)
Continuous functions such as volume are
learned, but operate only for a moment
before stopping.
POSSIBLE CAUSE
The batteries of this remote control unit are
weak.
The internal microcomputer “freezes”.
Wrong distance or angle.
Direct sunlight or lighting (of an inverter type of
flourescent lamp etc.) is striking the remotecontrol
sensor of the main unit.
The internal microcomputer “freezes”.
The batteries of this remote control unit and/or
the other remote control unit are weak.
The distance between the two remote control
units is too long or too short.
The signal coding or modulation of the other
remote control unit is not compatible with this
remote control unit.
Memory capacity is full.
The internal microcomputer “freezes”.
Learning process incomplete.
WHAT TO DO
Replace the batteries with new ones and press the RESET button on
the remote control unit.
Press the RESET button on the remote control unit.
The remote control unit will function from a maximum range of 6 meters,
no more than 30 degrees off-axis from the front panel.
Change position of the main unit.
Press the RESET button on the remote control unit.
Replace the batteries (and press the RESET button for this remote
control unit).
Place the remote control units with the proper distance.
Learning is not possible.
Further learning is not possible without deleting unnecessary
commands.
Press the RESET button on the remote control unit.
Be sure to press and hold the function key on the other remote control
until the TRANSMIT/LEARN indicator begins flashing slowly.
Remote control unit