Filter
Top Products
20
B PCM/ DIGITAL IN (COAXIAL and OPTICAL) jacks
Can be connected with audio/video units that have a coaxial or
optical digital output jack. Connect a unit that is connected to
the DVD/LD AUDIO/VIDEO SIGNAL connection jacks to the
DVD/LD COAXIAL or OPTICAL jack.
Connect a unit that is connected to the TV/DBS AUDIO/VIDEO
SIGNAL connection jacks to the TV/DBS COAXIAL jack.
* If, for example, your LD player has an AC-3 RF output jack
and no digital output jack for AC-3 discrete audio signals,
connect the AC-3 RF output jack to the DVD/LD COAXIAL or
OPTICAL jack of this unit by way of an RF demodulator
(separate purchase).
C ROOM 2 OUT Jacks
These jacks output audio and video signals to the equipment in
the second room. The signals of source output from these jacks
are selected by the REC OUT/ROOM 2 SELECTOR. Refer to
“CONNECTING AND CONTROLLING ROOM 2 EQUIPMENT”
on page 38.
D REMOTE CONTROL IN and OUT Jacks
The IN jack receives the commands from the central controller
for custom installation system. The OUT jack outputs the
commands received at the IN jack. Refer to “CONNECTING
AND CONTROLLING ROOM 2 EQUIPMENT” on page 38.
E Video NTSC/PAL Switch (General Model only)
Set this switch to the position corresponding to the standard
that your video equipment employs.
F MAIN LEVEL Switch
Normally set to “0 dB”. If desired, you can decrease the main-
channel output level at the MAIN SPEAKERS terminals by 10
dB by setting this switch to “–10 dB”.
G MAIN OUTPUT Jacks
Main-channel line output. Connected to input jacks of external
stereo power amplifier (MAIN IN or TAPE PLAY jacks of
integrated amplifier or receiver) when using external
amplification.
H SUBWOOFER Jacks
When using one subwoofer, connect its amplifier input to either
of these jacks. When using two subwoofers, connect their
amplifiers to these jacks respectively.
Frequencies below 90 Hz distributed from the main, center
and/or rear channels are output to these jacks.
Signals of LFE (low frequency effect) generated when the
Dolby Digital (AC-3) is decoded are also output if they are
assigned to these jacks.