Filter
Top Products
56
SYSTEM OPTIONS
Use this feature to reassign digital input/outputs, select the
input signal, rename the inputs, or adjust the level of the
signal input to each jack.
1 Set AMP/SOURCE/TV to AMP.
2 Press TOP on the remote control.
3 Select Input Select, then press h.
4 Select the desired input (CD, DVD, etc.), then
press h to access and adjust.
■ I/O Assignment
(Input / output assignment)
You can assign the digital audio input/output and
component video jacks to other components if this unit’s
initial settings do not correspond to your needs. Change
the following parameters to reassign the jacks and
effectively connect more components.
Once the jacks are reassigned, you can select the
corresponding component using INPUT SELECTOR on
the front panel or the input selector buttons on the remote
control.
Input Select > input source (DVD, etc.) >
I/O Assignment >
Example 1:
To assign the COAXIAL 7 (CD) jack to the DVD input.
1) Select Input Select, then select DVD.
2) Select I/O Assignment > Coaxial Input, then select
7 CD.
Example 2:
To clear a jack assignment.
1) Select Input Select, then select the input source (DVD,
etc.).
2) Select I/O Assignment, then select the jack assignment
(Optical Output, Optical Input, Coaxial Input or
Component Video).
3) Select NONE, then press ENTER to clear the
assignment.
y
This menu item is also available in the front panel display system
options menu (see page 85).
• You cannot select a specific item more than once for the same
type of jack.
• When you connect a component to both the COAXIAL and
OPTICAL jacks, priority is given to the input signals from the
COAXIAL jack.
■ Volume Trim (Volume trim)
Use this feature to adjust the level of the signal input to
each jack. This is useful if you want to balance the level of
each input source to avoid sudden changes in volume
when switching between input sources.
Input Select > input source (DVD, etc.) > Volume Trim >
Control range: –6.0 dB to +6.0 dB
y
This menu item is also available in the front panel display system
options menu (see page 85).
Input Select
AMP
SOURCE
TV
MD/TAPE
CD-R
DTV
CBL/SAT
DVD
Input Select
Manual Setup
Auto Setup
Stereo/Surround
Notes
Optical Input
Coaxial Input
Optical Output
I/O Assignment
Volume Trim
Rename