Filter
Top Products
55
English
SYSTEM OPTIONS
ADVANCED
OPERATION
Use the remote control to access and adjust each
parameter.
1 Set AMP/SOURCE/TV to AMP.
2 Press TOP on the remote control.
3 Press k / n repeatedly to select a menu, then
press h to enter the selected menu.
4 Press k / n repeatedly to select the
parameter you want to adjust.
5 Press ENTER or h, then press k / n
repeatedly to change the setting of the item
you want to adjust.
6 Press EXIT.
y
If you want to continue adjusting parameter settings, press
ENTER to return to the previously selected menu item.
• The available parameters may be displayed on more than one
page of the GUI display. To scroll through pages, press k / n.
• You cannot change parameter values when Memory Guard is
set to “Guard”. If you want to change the parameter values, set
Memory Guard to “Free” (see page 67).
Changing parameter settings
EXIT
MENU
EFFECT
RETURN
DISPLAY
STRAIGHT
NIGHT
AUDIO
PURE DIRECT
ENTER
TOP
TITLE
A/B/C/D/E
VOL
+
–
CH
+
–
TV VOL
TV MUTE TV INPUT
MUTE
+
–
AMP
SOURCE
TV
2
1
3-5
6
Center
Surround
Front
Speaker Set
Speaker Distance
Speaker Level
Test Tone
None
Large
Small
Surround
Surround Back
Presence
Center
Front
Notes
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cable is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the parameter values will return to the
factory settings. If this happens, edit the parameter
value again.
60Hz
40Hz
90Hz
100Hz
80Hz (THX)
Bass Cross Over
SWFR Phase
Bass Out
Presence
60Hz
40Hz
90Hz
100Hz
80Hz (THX)
Bass Cross Over
SWFR Phase
Bass Out
Presence