Filter
Top Products
25
English
CONNECTIONS
PREPARATION
Be sure this unit is in the standby mode.
1 On the front panel, while holding down
STRAIGHT/EFFECT, press STANDBY/ON.
“SP IMP.–8ΩMIN” appears on the front panel
display.
2 Press STRAIGHT/EFFECT to select the
impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3 Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
Speaker impedance setting function is located in the Advanced
menu (see page 84).
If you are using 6 ohm speakers, set the impedance to
6 ohms before turning on the power.
When all connections are complete, turn on the power of
this unit.
1 Press STANDBY/ON (SYSTEM POWER on the
remote controls) to turn on the power of this
unit.
2 Turn on the video monitor connected to this
unit.
Press STANDBY/ON again (STANDBY on the remote control)
to enter the standby mode.
Speaker impedance setting
Note
CAUTION
STRAIGHT
EFFECT
STANDBY
/ON
SP IMP.-8 MIN
Turning on the power
Note
VOLUME
VIDEO AUX
REC OUT
/ZONE 2
SPEAKERS
INPUT
MULTI CH
INPUT
INPUT MODE
PRESET
/
TUNING
SOURCE
/REMOTE
MD/TAPE
CD–R
TUNER
CD
DVD
D–TV
CBL/SAT
VCR 1
/VCR2
DVR
A/B/C/D/E
S VIDEO
MEMORY
FM/AM
EDIT
PRESET
/TUNING
MAN'L/AUTO FM AUTO/MAN'L MONO
TUNING
MODE
VIDEO AUDIO OPTICALLR
STANDBY
/
ON
A B
OPTIMIZER
MIC
TONE CONTROL
PROGRAM
STRAIGHT
EFFECT
PURE DIRECT
ZONE ON/OFF
MAIN ZONE 2
1
SILENT CINEMA
PHONES
YPAO
SELECT
DTV DVR/VCR2VCR 1 DVD
V
-
AUX
CBL/SAT MD/TAPE
CD-R
PHONO TUNER CD
MULTI CH IN
+
POWER POWER POWER
SYSTEM
STANDBY
AVTV
SLEEP
INPUT MODE
A
B
++
AMP
1
(U.S.A. model)
STANDBY
/ON
POWER
SYSTEM
or
Front panel
Remote control