Filter
Top Products
31
English
AUTO SETUP
PREPARATION
After auto setup
The following warning messages are displayed after analysis is complete to inform you of possible problems. We
recommend that you check the contents of each message, then select Retry to try the auto setup procedure again.
Warning message Cause Remedy
W1:Out of Phase Speaker polarity is incorrect. This message may
appear depending on the speakers even when
they are connected correctly.
• Check the speaker connections.
W2:Over Distance The distance between the speaker and the
listening position is over 24 m (80 ft).
• Bring the speaker closer to the listening position.
W3:Level Error The difference in volume level between the
speakers is excessive. (No level correction is
made.)
• Readjust the speaker installation.
• Check the speaker connections.
• Use speakers of similar quality.
• Adjust the output volume of the subwoofer.
W4:SP Mismatch The speaker settings differ from the
measurement results of wiring (only occurs
when the wiring measurement procedure is
skipped).
• Check the speaker connections.