Filter
Top Products
29
English
AUTO SETUP
PREPARATION
You can confirm the results of each analysis.
If you set Setup Type to Auto.
The results are displayed after all items have been
analysed.
• Press n and select Setup to set the measured values.
• Press k and select Retry to retry the auto setup procedure.
• Press h and select Detail to view information about
measurement results and warning messages. For more
details about warning messages, see “Troubleshooting for
the auto setup procedure” on page 30.
• Press l and select Exit to exit from the auto setup
procedure. If you select Exit, “Don’t Setup?” appears on
the screen. To set the measured values and exit, select Yes.
To cancel the settings and exit, select No.
If you set Setup Type to Step.
The results are displayed individually after each analysis.
•Press n and select Next to start measurement of the next
menu item.
•Press k and select Retry to retry the auto setup procedure.
•Press h and select Detail to view information about
measurement results and warning messages. For more
details about warning messages, see “Troubleshooting for
the auto setup procedure” on page 30.
•Press l and select Exit to exit from the auto setup
procedure.
After all menu items have been measured, “Measurement
Over” appears on the screen and the results for each item
are displayed.
•Press n and select Setup to set the measured values.
•Press k and select Retry to retry the auto setup procedure.
•Press h and select Detail to view information about
measurement results and warning messages. For more
details about warning messages, see “Troubleshooting for
the auto setup procedure” on page 30.
•Press l and select Exit to exit from the auto setup
procedure. If you select Exit, “Don’t Setup?” appears on
the screen. To set the measured values and exit, select Yes.
To cancel the settings and exit, select No.
y
If you want to make more detailed settings, change the system
parameters using the Manual Setup menu. If you want to return to
the Auto Setup settings after making settings in the Manual Setup
menu, navigate to the Information screen in the Auto Setup menu,
press k / n repeatedly to select the parameter you want to adjust,
then press ENTER.
• If you change speakers, speaker positions, or the layout of your
listening environment, perform auto setup again to re-calibrate
your system.
• In the Distance results, the distance displayed may be longer
than the actual distance depending on the characteristics of your
subwoofer. This may also be the case when using an external
amplifier.
• In the Equalizing results, different values may be set for the
same band to provide finer adjustments.
Confirming the results
Measurement Over
Successfully
Start
Setup Type
Setup Menu
Retry
Setup
Exit Detail
Notes
Equalizing
Size
Distance
Level
Result
Retry
Next
Exit Detail