Filter
Top Products
84
MANUAL SETUP
■ Input rename B)INPUT RENAME
Use this feature to change the name of the inputs in the
OSD and front panel display.
1 Press an input selector button to select the
input you want to change the name of.
2 Set AMP/SOURCE/TV to AMP.
3 Press l / h to place the _ (under-bar) under
the space or the character you want to edit.
4 Press k / n to select the character you want
to use and l / h to move to the next one.
• You can use up to 8 characters for each input.
• Press n to change the character in the following
order, or press k to go in the reverse order:
A to Z, space, 0 to 9, space, a to z, space, #, *, +,
etc.
5 Repeat steps 1 through 4 to rename each
input.
6 Press ENTER or RETURN on the remote
control to exit from the INPUT RENAME
menu.
■ Volume trim C)VOLUME TRIM
Use to adjust the level of the signal input at each jack. This
is useful if you want to balance the level of each input
source to avoid sudden changes in volume when switching
between input sources.
Choices: –6.0 dB to +6.0 dB
Initial setting: 0.0 dB
You can only adjust the volume for the current input source using
this setting.
■ Decoder mode D)DECODER MODE
Use to switch the input mode. You can designate the
reassigned digital input jacks for specific audio signals
(DTS, etc.).
Choices: AUTO, DTS
• Select AUTO if you want this unit to automatically
detect input signal types and select the appropriate
input mode.
• Select DTS if you want this unit to select DTS as the
input mode.
■ Multi CH Setup E)MULTI CH SET
Use to set the direction of the signals input into the center,
subwoofer and surround channels when a source
component is connected to the MULTI CH INPUT jacks.
If you input 8-channel signals from an external decoder,
use this feature to select jacks for the additional front
signals.
INPUT CH
Use this setting to select the number of channels input
from an external decoder.
Choices: 6CH, 8CH
• Select 6CH if you input 6-channel signals.
• Select 8CH if you input 8-channel signals.
If ZONE2 AMP is set to SUR, PRNS or BOTH (see page 87), no
sound is output from the surround back speakers even if you
select 8CH. In this case, select 6CH and set the output setting of
the external component to 6 channels.
FRONT
If you selected 8ch in INPUT CH, you can select analog
jacks at which front signals from an external decoder will
be input.
Choices: MD/TAPE, CD-R, CD, DVD, DTV, CBL/SAT,
VCR1, DVR/VCR2, V-AUX
Note
DVD -> DVD
B)INPUT RENAME
[<]/[>]:Position
[]/[]:Chara.
p
p
C)VOLUME TRIM
. PHONO 0.0dB
CD 0.0dB
CD-R 0.0dB
MD/TAPE 0.0dB
[]/[]:Up/Down
[<]/[>]:Adjust
p
p
Note
D)DECODER MODE
[]/[]:Up/Down
[<]/[>]:Adjust
p
p
. CD ;;;;AUTO
DVD ;;;;AUTO
DTV ;;;;AUTO
CBL/SAT ;;;;AUTO
. INPUT CH;;;;;6CH
FRONT;;;;;;;;DVD
E)MULTI CH SET
[]/[]:Up/Down
[<]/[>]:Adjust
p
p