Filter
Top Products
16
CONNECTIONS
1 Remove approximately 10 mm (3/8 in) of
insulation from each of the speaker cables.
2 Twist the exposed wires of the cable together
to prevent short circuits.
3 Loosen the knob using the supplied speaker
terminal wrench.
4 Insert one bare wire into the hole on the side
of each terminal.
5 Tighten the knob to secure the wire using the
supplied speaker terminal wrench.
6 Hook the speaker terminal wrench onto
WRENCH HOLDER on the rear panel of this
unit when not in use.
10 mm (3/8 in)
Red: positive (+)
Black: negative (–)
Speaker terminal wrench
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)
Speaker terminal wrench