Filter
Top Products
31
CONNECTIONS
PREPARATION
3 Press MAIN ZONE ON/OFF, ZONE 2 ON/OFF
or ZONE 3 ON/OFF on the front panel (or
POWER on the remote control) to turn on this
unit, Zone 2 or Zone 3.
y
• When MASTER ON/OFF is pressed inward to the ON
position, you can also press POWER or STANDBY on the
remote control to turn on or set this unit, Zone 2 and Zone
3 to the standby mode simultaneously.
• For details about controlling Zone 2 and Zone 3 using the
remote control, see page 106.
MAIN ZONE ON/OFF, ZONE 2 ON/OFF and ZONE 3
ON/OFF on the front panel as well as POWER and
STANDBY on the remote control are operational only when
MASTER ON/OFF is pressed inward to the ON position.
4 Press MASTER ON/OFF on the front panel
again to release it outward to the OFF
position to turn off this unit.
This unit, Zone 2 and Zone 3 are turned off.
Follow the procedure below to change the impedance
setting for all speakers.
If you are using 6 ohm speakers, set the impedance to
6 ohms before using this unit.
1 Press MASTER ON/OFF on the front panel to
release it outward to the OFF position to set
this unit, Zone 2 and Zone 3 to the standby
mode.
2 Press and hold STRAIGHT (EFFECT) on the
front panel and then press MASTER ON/OFF
inward to the ON position to turn on the
power of this unit.
SP IMP.–8ΩMIN appears in the front panel display.
3 Press STRAIGHT (EFFECT) on the front
panel repeatedly to select the impedance of
your speakers.
• Select 6 ohms if you are using 6 ohm speakers.
4 Press MASTER ON/OFF on the front panel to
release it outward to the OFF position to save
the new setting and set this unit, Zone 2 and
Zone 3 to the standby mode.
This unit will be set to the standby mode.
You can also set the speaker impedance by using the SP
IMP. parameter in the ADVANCED SETUP menu (see
page 90).
Note
ON/OFF
POWER
or
Front panel Remote control
MASTER
ON
OFF
Setting the speaker impedance
CAUTION
Note
MASTER
ON
OFF
STRAIGHT
EFFECT
MASTER
ON
OFF
SP IMP.-8 MIN
ADVANCED SETUP
STRAIGHT
EFFECT
MASTER
ON
OFF