Filter
Top Products
81
ZONE 2/ZONE 3 (U.S.A., CANADA, U.K., EUROPE AND AUSTRALIA MODELS ONLY)
ADVANCED
OPERATION
English
Using this unit’s internal amplifier
To use this unit’s internal amplifier, set ZONE2 AMP to ON in SET MENU (see page 67).
The supplied remote control can be used to control
Zone 2/Zone 3. You can even select the input source and
control components located in the main room directly
from the second/third room regardless of the listening
condition in the main room.
■ To enable Zone mode on the remote
control
You will be able to switch the remote control mode from
one room to another, and use the input selector,
STANDBY, SYSTEM POWER, MUTE and VOLUME +/
– to control the selected room.
1 Repeat steps 1 through 3 of the procedure in
“Setting remote control codes” on page 69.
2 Press l / h to select “L:AMP”.
3 Press ENTER.
“2000” appears in the display window.
4 Enter the code number “2001”.
5 Press ENTER to set the number.
“OK” appears in the display window if setting was
successful.
6 Press LEARN to complete the Zone setup.
The remote control will be able to operate this unit
from Zone 2 or Zone 3.
■ To control Zone 2/Zone 3
1 Press SELECT k repeatedly to display
“ZONE 2” or “ZONE 3” in the display window.
2 Press SYSTEM POWER to turn Zone 2 or
Zone 3 power on.
3 Press an input selector button to select the
input source you want to listen to in the
second/third room.
The display window shows “2: name of selected
input” or “3: name of selected input” if the remote
control is in the Zone 2/Zone 3 mode.
Signals input to V-AUX and PHONO jacks cannot be sent to
Zone 2/Zone 3.
R
L
+
–
PRESENCE/ ZONE 2
Second room
This unit
Remote controlling Zone 2/Zone 3
ENTER
LEARN
Note
SELECT
or
DTV DVR/VCR2VCR 1 DVD
V
-
AUX
CBL/SAT MD/TAPE
CD-R
PHONO TUNER CD
MULTI CH IN
SLEEP
INPUT MODE
A
B