Filter
Top Products
27
AUTO SETUP
PREPARATION
English
For best results, make sure the room is as quiet as possible
during the auto setup procedure (YPAO). If there is too
much ambient noise, the results may not be satisfactory.
y
If your subwoofer can adjust the output volume and the crossover
frequency, set the volume to about half way (or slightly less) and
set the crossover frequency to the maximum.
1 Switch on this unit and video monitor.
Make sure the OSD is displayed (see page 53).
2 Set AMP/SOURCE/TV to AMP, then press
SET MENU to enter the SET MENU.
3 Press k / n to select AUTO SETUP, then
press h once to enter the main menu.
4 Press k / n repeatedly to select WIRING,
DISTANCE, SIZE, EQUALIZING or LEVEL.
5 When WIRING, DISTANCE, SIZE or LEVEL is
selected, press l / h to select:
CHECK
To automatically check and adjust the selected
item.
SKIP To skip the selected item and perform no
adjustments
.
When using THX speakers, set SIZE to SKIP and make sure
that “SMALL” or “SMLx2” is selected in SPEAKER SET
(page 58) and that 80Hz (THX) is selected in CROSS
OVER (page 60).
When EQUALIZING is selected, press l / h
to select:
FRONT To adjust the frequency response of
each speaker in accordance with the
sound of your front speakers.
Recommended if your front speakers
are of much higher quality than your
other speakers.
FLAT To average the frequency response of
all speakers. Recommended if all of
your speakers are of similar quality.
LOW To average the frequency response of
all speakers, giving priority to the
accuracy of bass frequencies.
MID To average the frequency response of
all speakers, giving priority to the
accuracy of mid-range frequencies.
HIGH To average the frequency response of
all speakers, giving priority to the
accuracy of high frequencies.
SKIP To skip the selected item and perform
no adjustments.
6 Press n to select SETUP, then press l / h to
select:
AUTO To automatically perform the entire
auto setup procedure.
STEP To pause for confirmation between
each check in the auto setup procedure.
RELOAD To restore the last auto setup setting.
Starting the setup
CROSSOVER/
HIGH CUT
MIN
MAX
Subwoofer
VOLUME
MIN
MAX
SET MENU
MENU
AMP
SOURCE
TV
then
ENTER
ENTER
SET MENU
. ;AUTO SETUP
;MANUAL SETUP
: Up/Down
p
/
p
: Enter
</>
Note
1
AUTO:MENU
.WIRING;;;;;CHECK
DISTANCE;;;CHECK
SIZE;;;;;;;CHECK
EQUALIZING;;FLAT
LEVEL;;;;;;CHECK
SETUP;;;;;;;AUTO
START PUSH
: Up/Down
p
/
p
: Select
</>
>