Yamaha RX-V1500 Stereo System User Manual


 
61
SET MENU
ADVANCED
OPERATION
English
Graphic equalizer D)GRAPHIC EQ
Use this feature to select parametric (PEQ) or graphic
equalizer (GEQ).
Equalizer select EQ SELECT
Choices: PEQ, GEQ
Select “PEQ” to use the equalizer adjusted in auto
setup.
Select “GEQ” to adjust the built-in 7-band graphic
equalizer (see “Equalizer” below).
Equalizer
Use to match the tonal quality of the center, surround L/R
and surround back L/R speakers with that of the front L/R
speakers.
Choices: –6 to +6 (dB)
You can adjust 7 frequency bands: 63Hz, 160Hz, 400Hz,
1kHz, 2.5kHz, 6.3kHz, 16kHz
Low-frequency effect level E)LFE LEVEL
Use to adjust the output level of the LFE (low-frequency
effect) channel according to the capacity of your
subwoofer or headphones. The LFE channel carries low-
frequency special effects which are only added to certain
scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.
Choices: –20 to 0 (dB)
Speaker SPEAKER
Select to adjust the speaker LFE level.
Headphone HEADPHONE
Select to adjust the headphone LFE level.
Depending on the settings of LFE LEVEL, some signals may not
be output from the SUBWOOFER PRE OUT jack.
Dynamic range F)DYNAMIC RANGE
Use to select the amount of dynamic range compression to
be applied to your speakers or headphones. This setting is
effective only when the unit is decoding Dolby Digital and
DTS signals.
Choices: MIN (minimum), STD (standard),
MAX (maximum)
Speaker SP
Select to adjust the speaker compression.
Headphone HP
Select to adjust the headphone compression.
Select “MIN” if you regularly listen at low volume
levels.
Select “STD” for general use.
Select “MAX” to preserve the greatest amount of
dynamic range.
Note
. EQ SELECT....PEQ
/ : Up/Down
p
p
</> : Select
D) GRAPHIC EQ
. CHANNEL;;FRONT L
-+
63Hz 0dB
160Hz 0dB
400Hz 0dB
1kHz 0dB
2.5kHz 0dB
6.3kHz 0dB
16kHz 0dB
D)GRAPHIC
EQ
. SPEAKER;;;;;;0dB
HEADPHONE;;;;0dB
/ : Up/Down
p
p
</> : Adjust
E)LFE
LEVEL
. SP: MIN STD[MAX
HP: MIN STD[MAX
/ : Up/Down
p
p
</> : Select
F)DYNAMIC RANGE