Filter
Top Products
30
AUTO SETUP
After auto setup
Press l / h to display the detailed information about individual warnings.
• If the ERROR or WARNING screens appears, check the cause of the problem, then perform the auto setup procedure again.
• If warning W-1, W-4 or W-5 appears, corrections are made, but they may not be optimal.
• If warning W-2 or W-3 appears, no corrections are made.
• If error E-10 occurs repeatedly, please contact a qualified YAMAHA service center.
Warning message Cause Remedy
W-1:OUT OF PHASE
Speaker polarity is not correct. This message
may appear depending on the speakers even
when the speakers are connected correctly.
• Check the speaker connections for proper polarity
(+ or –).
W-2:OVER 24m
(80ft)
The distance between the speaker and the
listening position is over 24 m (80 ft).
• Bring the speaker closer to the listening position.
W-3:LEVEL ERROR
The difference of volume level among speakers
is excessive. (No level correction is made.)
• Readjust the speaker installation so that all speakers
are set in locations with similar conditions.
• Check the speaker connections.
• Use speakers of similar quality.
• Adjust the output volume of the subwoofer.
W-4:SWFR PHASE
The phase polarity of the subwoofer is not
correct.
• Select the opposite phase on the subwoofer if the
subwoofer has a phase switch.
W-5:VOL ERROR
The result may not be correct because the
volume was changed during the auto setup
procedure.
• Perform the auto setup procedure again. Do not
change the volume during the auto setup procedure.