Filter
Top Products
49
English
INTRODUCTION
PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
REMOTE CONTROL FEATURES
CLEAR
CLEAR
CLEAR
Clearing Learned Functions,
Renamed Source Names, and
Setup Manufacturer Codes
You can clear learned functions, renamed source names
and set up manufacture codes. You can also revert the
remote control to the factory setting.
1 Press CLEAR by using a ballpoint pen or
similar object.
Note
• If you do not press any button within 30 seconds during steps 2
and 3, the clearing process is canceled. If this happen, start over
from step 1.
2 Press u / d to select the clear mode.
The mode is shown in the display window in the
following order:
3 Press and hold CLEAR again for about 3
seconds.
“C:OK” appears in the display window.
Note
•“C:NG” appears in the display window if the operation is
unsuccessful. In this case, start over from step 2.
4 Press CLEAR to exit from the clearing mode.
Note
•“ERROR” appears in the display window when pressing
buttons other than indicated in each step, or more than one
button at once.
(L: name of a component) Clears
all learned functions for the
component area.
Clears all learned functions for
this unit control area.
Clears all learned functions.
Clears all renamed source names
in the display window.
Clears all programmed functions
including setup manufacturer
codes. This returns to the factory
settings.
TV VOL
PRESET PRESET
TV MUTE
TV VOL
SELECT
CHCH
+
+
–
–
0108HTR5590_44-54_EN(U) 02.8.5, 4:31 PM49