Filter
Top Products
33
English
INTRODUCTION
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
BASIC PLAYBACK
Front panel
or
Remote control
STEREO
EFFECT
STEREO
EFFECT
■ Normal Stereo Reproduction
Press STEREO/EFFECT to turn off the sound
effect for normal stereo reproduction.
Press STEREO/EFFECT again to turn the sound
effect back on.
Notes
• If “1B MAIN SP” on the SET MENU is set to “SMALL” and
“1E LFE/BASS OUT” is set to “SW”, or “1E LFE/BASS
OUT” is set to “BOTH”, the LFE signals will be output from
the subwoofer.
• If you turn off the sound effect while a Dolby Digital or DTS
signal is being output, the dynamic range of the signal is
automatically compressed and the sounds of the center and rear
speaker channels are mixed and output from the main speakers.
• The volume may be greatly reduced when you turn off the
sound effect or if you set “11 D-RANGE” on the SET MENU
to MIN. In this case turn on the sound effect.
■ Displaying the information about
the input source
You can display the information such as the type, format
and sampling frequency of the signal input from the
component connected to this unit during stereo
reproduction.
(While playing a source)
1 Press AMP to select the AMP mode.
2 Press d/u to display the information about
the input signal.
TV VOL
PRESET PRESET
TV MUTE
TV VOL
SELECT
CHCH
+
+
–
–
0105HTR5590_27-33_EN(U) 02.8.5, 4:30 PM33