Open as PDF
MANUAL PRESET TUNING
This unit can store station frequencies selected by tuning operation. With this function, you can recall any desired station by
selecting the preset station number where it is stored. Up to 40 stations (5 groups of 8 stations) can be stored.
2 , 11 4 , 22
To store stations
1 Tune to a desired station.
(Refer to the previous page for tuning procedure.)
2 Select a desired group (A – E) of preset stations
confirming it in the display.
4 Select a preset station number where you want to
program the station while the “MEMORY” indicator
appears in the display.
* In the same way, program other stations to A2, A3 ... A8.
* You can program more stations to preset station numbers
on other groups in the same way by selecting other
groups in step 2.
Shows the displayed station has been
programmed to A1.
To recall a preset station
Flashes on and off for
about 5 seconds.
11 Select the group of preset stations.
22 Select the preset station number.
● A new setting can be programmed to replace a former
● For presets, the setting of the reception mode (stereo or
monaural) is stored along with the station frequency.
The memory back-up circuit prevents the programmed data
from being lost even if this unit is put in the standby mode, the
power plug is disconnected from the AC outlet, or the power is
cut due to temporary power failure. If, however, the power is
cut for more than one week, the memory may be erased. If so,
it can be re-programmed by simply following the PRESET