Filter
Top Products
26
TUNING OPERATIONS
Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).
LR
1
32
4
AUTOMATIC TUNING
1 Select “TUNER” as the input source.
2 Select the reception band (FM or AM) confirming it in
the display.
3
4 To tune to a higher frequency, press the right side once.
To tune to a lower frequency, press the left side once.
* If the station where tuning search stops is not the desired
one, press again.
* If the tuning search does not stop at the desired station
(because the signals of the station are weak), change to
the MANUAL TUNING method.
TAPE/MD
MONITOR
TUNER
CD
PHONO
FM
/
AM
or
TUNING
MODE
AUTO
/
MAN'L MONO
AUTO
DOWN UP
TUNING
MANUAL TUNING
TAPE/MD
MONITOR
TUNER
CD
PHONO
FM
/
AM
or
TUNING
MODE
AUTO
/
MAN'L MONO
Turn the “AUTO”
indicator off.
DOWN UP
TUNING
1 Select “TUNER” as the input source.
2 Select the reception band (FM or AM) confirming it in
the display.
3
4 Tune to a desired station manually.
* For a continuous tuning search, press and hold the
button.
Notes
● If you tune to an FM station manually, it is received in
monaural mode automatically to increase the signal quality.
● HTR-5130RDS only When tuned to a station, the
frequency of the received station is shown on the display. If
an RDS station that employs PS data service is received,
the frequency is then replaced by the station name. Refer to
page 32 for details.