Open as PDF
TO RECORD A SOURCE TO TAPE OR MD
1Select the source to be recorded.
2 Play the source and then turn the VOLUME control up
to confirm the input source. (For detailed information
on tuning operations, refer to the page 26.)
3 Begin recording on the tape deck (or MD recorder, etc.)
or VCR connected to this unit.
4 If the tape deck (or MD recorder, etc.) is used for
recording, you can monitor the sounds being recorded
by pressing TAPE/MD MONITOR so that the “TAPE
MON” indicator lights up on the display.
● The settings of DSP and the VOLUME, BASS, TREBLE and
BALANCE controls have no effect on the material being
● In step 1, do not make an input source selection so that
“6ch” appears on the display. Signals input to this unit’s 6CH
DISCRETE INPUT terminals cannot be recorded by a tape
deck, MD recorder or VCR.