Filter
Top Products
52 En
Using audio features
You can adjust the output level of each speaker while
listening to a music source. This is also possible when
playing sources input at the MULTI CH INPUT jacks.
This operation will override the level adjustments made in “Auto
Setup” (see page 37) and “Speaker Level” (see page 94).
1
Press
3
LEVEL
on the front panel repeatedly
to select the speaker you want to adjust.
y
• Once you press
3
LEVEL on the remote control, you can
also select the speaker by pressing 4k / n.
• Instead of “SB R” and “SB L”, “SB” is displayed if
“Surround Back” is set to either “Small x1” or “Large x1”
(see page 92).
2 Press 4l / h to adjust the speaker output
level.
• Press 4h to increase the value.
• Press 4l to decrease the value.
Control range: –10.0 dB to +10.0 dB
You can mix down multi-channel sources to 2 channels
and enjoy playback in 2-channel stereo.
Press
O
STEREO on the remote control
repeatedly to select “2ch Stereo”.
y
• You can use a subwoofer with this program when “Bass Out” is
set to “SWFR” or “Both” (see page 92).
• You can also select the “2ch Stereo” mode by rotating the
O
PROGRAM selector on the front panel.
• You can also select the “2ch Stereo” mode and adjust the
parameter by using GUI screen. See page 74 for details.
• See page 79 for details about the parameters of the “2ch Stereo”
mode.
Before performing the following operation, set the operation
mode selector on the remote control to
D
AMP.
Adjusting the speaker level
Note
Display Adjusted speaker
FRONT L
Front left speaker
CENTER
Center speaker
FRONT R
Front right speaker
SUR. R
Surround right speaker
SB R
Surround back right speaker
SB L
Surround back left speaker
SUR. L
Surround left speaker
SWFR
Subwoofer
PRNS L
Presence left speaker
PRNS R
Presence right speaker
Enjoying multi-channel sources in
2-channel stereo