Filter
Top Products
33 En
Connections
PREPARATION
English
Before using this unit, set the speaker impedance of the
connected speakers and the language of the menu items
and messages, that appears in the GUI (graphical user
interface) screen of this unit.
1 Make sure this unit is turned off.
2 Press and hold
P
STRAIGHT on the front
panel and then press
A
MASTER ON/OFF
inward to the ON position to turn on this unit.
This unit turns on, and the advanced setup menu (see
page 122) appears in the front panel display.
3 Rotate the
O
PROGRAM selector to select
“SPEAKER IMP.”.
4 Press
P
STRAIGHT repeatedly to select
“6ΩMIN”.
5 Rotate the
O
PROGRAM selector to select
“GUI LANGUAGE”.
6 Press
P
STRAIGHT repeatedly to select the
desired language setting for the GUI screen
in the video monitor.
Choices: ENGLISH (English), JAPANESE
(Japanese), FRENCH (French), GERMAN
(German), SPANISH (Spanish), RUSSIAN
(Russian)
• This setting does not affect to the messages that appear in the
front panel display.
• You can also select the GUI language by using GUI screen. See
page 99 for details.
7 Press
A
MASTER ON/OFF to release it
outward to the OFF position to save the new
setting and turn off this unit.
The setting you made is reflected next time you turn
on this unit.
■ Turning on this unit
Press
A
MASTER ON/OFF on the front panel
inward to the ON position to turn on this unit.
When you turn on this unit by pressing
A
MASTER ON/
OFF, the main zone is turned on.
y
When you turn on this unit, there will be a delay for a few
seconds before this unit can reproduce sound.
■ Turning off this unit
Press
A
MASTER ON/OFF on the front panel
again to release it outward to the OFF position to
turn off this unit.
•
B
MAIN ZONE ON/OFF on the front panel as well as
9
POWER and
8
STANDBY on the remote control are
operational only when
A
MASTER ON/OFF is pressed
inward to the ON position.
• Basically, we recommend that you use the standby mode to turn
off this unit.
■ Turning on the main zone from the
standby mode
Press
B
MAIN ZONE ON/OFF
(or
8
STANDBY
)
to set the main zone to the standby mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
■ Set the main zone to the standby mode
Press
B
MAIN ZONE ON/OFF (or
9
POWER) to
turn on the main zone.
y
• When you turn on this unit, there will be a delay for a few
seconds before this unit can reproduce sound.
• These buttons are operational only when
A
MASTER ON/
OFF is pressed inward to the ON position.
Setting the speaker impedance
and GUI language
Caution
If you are to use 6-ohm speakers, set “SPEAKER IMP.”
to “6ΩMIN” as follows BEFORE using this unit. You
can also use 4-ohm speakers as the front speakers.
Notes
EFFECT
STRAIGHT
MASTER
While holding
down
Turning this unit on and off
Notes
If there are some problems...
• First, turn off and then turn on this unit again.
• If problems persist, initialize the parameters of this
unit. See page 137 for details.