Filter
Top Products
102 En
Saving and recalling the system settings (System Memory)
■ Loading by the SET MENU operation
1 Press
G
SET MENU on the remote control.
The top menu appears in the GUI.
2 Press
4
k / n repeatedly to select “System
Memory” and then press
4
h.
The “System Memory” menu appears in the GUI.
3 Press
4
k / n to select “Load” and then
press 4h.
The following menu appears in the GUI.
4 Press
4
k / n repeatedly to select the desired
memory number where the system settings
are stored and then press
4
h.
Once “Load: ENTER” appears in the GUI, press
4ENTER to confirm the loading.
y
You can cancel the loading by pressing 4l.
5 Press
G
SET MENU to exit from GUI screen.
■ Example 1: Comparing the results of the
automatic setup and manual setup
This unit is equipped with three types of parametric
equalizer settings (see page 40), and you can also make
your customized configuration of the sound settings of this
unit by using the “Manual Setup” parameters (see
page 85). To compare the results of the automatic setup or
your manual configuration, use the NSYSTEM
MEMORY buttons.
Saving each setting
Carry out the following procedure when all the parameters are set
to default values.
1 Press and hold
N
SYSTEM MEMORY 1 for
four seconds.
This unit stores the current settings of this unit to
“Memory1”.
2 Perform the automatic setup.
Set “Equalizing” to “Check:Natural”. See page 40 for
details.
3 Press and hold
N
SYSTEM MEMORY 2 for
4 seconds.
This unit stores the results of the automatic setup
performed in step 2 to “Memory2”.
4 Perform the automatic setup again.
This time, set “Equalizing” to “Check:Front”.
5 Press and hold
N
SYSTEM MEMORY 3 for
4 seconds.
This unit stores the results of the automatic setup
performed in step 4 to “Memory3”.
Current
Memory1
Memory2
Sci-Fi
SpeakerCH 3/2/0.1
LFE Level 0dB
D-Range MAX
PEQ YPAO Natural
Memory1
Memory2
Memory3
Memory4
Memory5
Pure Direct
SpeakerCH 5/4/0.1
LFE Level 0dB
D-Range MAX
PEQ YPAO Flat
Using examples
Note
4
5
7
6
8
CLASSICAL LIVE/CLUB
ENTERTAIN
MOVIE
SYSTEM MEMORY
3
2
1
SYSTEM MEMORY 1
The current settings of this unit
SYSTEM MEMORY 2
The results of the automatic setup
(Equalizing: Check:Natural)
SYSTEM MEMORY 3
The results of the automatic setup
(Equalizing: Check:Front)