Filter
Top Products
OPTIMIZING THE SPEAKER SETTING FOR YOUR LISTENING ROOM (YPAO)
37 En
PREPARATION
English
This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening
environment.
• Be advised that it is normal for loud test tones to be output
during the automatic setup procedure.
• To achieve the best results, make sure the room is as quiet as
possible while the automatic setup procedure is in progress. If
there is too much ambient noise, the results may not be
satisfactory.
y
• If an error occurs during the automatic setup procedure and an
error or warning message appears in the GUI screen or in the
front panel display, see the “Auto Setup” section in
“Troubleshooting” on pages 135 and 136 for a complete list of
error and warning messages and proper remedies.
• The initial setting for each parameter is indicated in bold.
• Before performing operations, set the operation mode selector
on the remote control to
D
AMP.
■ Basic procedure of the automatic setup
1 Make sure of the following check points
before starting the automatic setup
operations.
❏ Speakers are connected appropriately.
❏ Headphones are disconnected from this unit.
❏ This unit and the video monitor are turned on.
❏ The connected subwoofer is turned on and the
volume level is set to about half way (or slightly
less).
❏ The crossover frequency controls of the
connected subwoofer is set to the maximum.
❏ If you use the external amplifiers (see page 28),
the amplifiers are turned on and the settings are
appropriate.
❏ The room is sufficiently quiet.
2 Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
“MIC ON” and “View OSD MENU” appears in the
front panel display.
The following menu screen appears on the video
monitor.
y
Following message appears in the front panel display after a
while. You can only perform the automatic setup with the
GUI menu.
Optimizing the speaker setting for your listening room (YPAO)
Using the automatic setup
(Auto Setup)
Notes
VOLUME
MIN
MAX
MIN MAX
CROSSOVER
HIGH CUT
Controls of a subwoofer (example)
SLEEP
ZONE ON/OFF
ZONE CONTROLS
MIC
OPTIMIZER
EFFECT
STRAIGHT
CONTROL
SELECT
AUDIO
TONE
REC OUT/
ZONE2
PROGRAM
ZONE 3
R
L
OPTICAL
USB
ZONE 2
AUDI O
VIDEO AUX
SILENT CINEMA
S VIDEO
VIDEO
PHONES
DISPLAY
MODE
TUNING
PRESET/TUNING/CH
SEARCH MODE
EDIT
FM/AM
PRESET/
TUNING
MAN'L/AUTO FM
MEMORY
CATEGORY
A/B/C/D/E
MULTI ZONE
YPAO
Omni-directional
microphone
MIC ON
VIEW OSD MENU
Information
Setup Menu
Start Start: ENTER
GUI
RX-V3800