Filter
Top Products
• XM Satellite Radio
Error message
i==i...ii:::'i==i..' ¢"1H "r'i:::' i..ii..h"i
,...=i H....,...=F.. r'_H i L..HHr"I
i {_::,r'.,l%T 'i'i..h';3
,..q L.'r'_ i .LH'..a
1%..' ...l.l. _...ll_r'_l
'...ll I r"l .l. l".
._"_..=M % ..............
............... ...' ...............
Cause
Tile XM Connect-and-Play digital antenna
accessory is not connected, or does not work
properly.
The XM user encryption code is being updated.
The signal istoo weak.
It lakes longer Ihan four seconds for audio or
lexl data Iobc decoded.
The XM Satellite Radio channel you selected is
not currently broadcasting any signal.
The channel station ID (SID) is no longer
available.
No artisl name/fealure or song/program title is
available.
No channels are available for Ihe selected
calegory.
Remedy
Check the XM Connect-and-Play digilal anlcnna accessory
conneclk)ns.
Wait until the encryption code isupdated.
Check the XM Connect-and-Play digital antenna accessory
connections and orient it for thebest reception.
Wait until the decoding process has finished.
Check the channel number again or selecl another XM
Satellilc Radio channel.
Select anolher channel category by pressing CATEGORY on
the fronl panel (or A-E/CAT. < / >on Ihe remote control)
repealedly.
• Remote control
See
Problem Cause Remedy
page
The remote control W_ongdistance m angle The _emote control will function within a maximtm]
does not work nor range of 6 m (197 :_)and no more than 30 degrees 9
function properly, off-axis flora the fiont panel.
Direct sunlight or ligD'ing (flora an Reposition thisunit.
inverter type of fluorescent lamp, ere ) is
striking the remote com_ol sensor of this
unit.
The batteries are weak. Replace all battmies. 9
The remote control ID and this unit's ID Switch the remote control ID or this unit's ID.
35.36
do not n]atch
The remote com!ol code was not correctly T*y setting another code of the same manufactmer
set. using "LIST OF REMOTE CONTROL CODES" at 41
the end of this manual.
Even ifthe remote connol code is Use the supplied remote control tbr thecomponents.
correctly set, there are some models that
do not respond tothe remote control.
44