Filter
Top Products
l_t',l_h'N=,',I"I"iIq"
Press the preset station/channel number
buttons (1 and 2) on the front panel
repeatedly to move through the menu and
select the parameter you want to adjust.
See page 35 for a complete list of available
parameters.
You can select the unit you want to operate with the
remote control by switching the remote control ID.
1 Press and hold CODE SET on the remote
control and then press TUNER on the remote
control.
Press AIB/C/DIE on the front panel
repeatedly to toggle between the available
parameters.
Press MASTER ON/OFF to release it outward
to the OFF position to confirm your setting.
MA'_TE_
The settings you made are reflected next time you turn on the
power of this unit.
CODESET
While holding down CODE SET on the
remote control, use the numeric buttons on
the remote control to enter the three-digit
code number listed in the table below.
CODESET
Remote
control ID:'
Function Code number
(this unit's
setting)
To operate this
ID l unit using an 801
alternative code.
ID2 To operate this
unit using the 802
(default setting) det;ault code.
* \_len you change the remote control ID, you must switch
the remote control ID of this unit (see page 35).
When using multiple YAMAHA receivers or
amplifiers with the same default code setting, you
may unwantedly operate those components
simultaneously. In this case, set one of the alternative
codes for this unit to operate this unit separately.
Also change the remote control ID of the Zone 2 remote control
(sold separately) (see page 9).
36